Removing and Installing Thermostats D Drain off coolant, see Page 43 D Remove expansion tank, see page 47 Fig. 1 Once the expansion tank has been removed the thermostats in the water pump housing are visible. 1 Fig. 2 Take out thermostat. Check the function of the thermostat insert as fol- lows. D Suspend the thermostat in a bowl of water D Heat up the water D Using a suitable thermometer, ascertain the start of opening and compare it with the setpo- int value in “Engineering S Data S Setting Va- lues” D If necessary, measure the opening stroke Replace defective thermostats. 2 Fig. 3 Insert thermostat inserts (ball valve facing upwards (TOP) with new O−ring seal А and new seal Б . Caution:
Never operate the engine without its ther- mostats. 3 1 2 46