MAN — Draining and filling coolant

Draining and filling coolant D Before the engine is next put into operation (with the engine cold) check the coolant level and top up if necessary D Repeat this procedure until no more coolant can be added Note: The turbochargers must not be bled while the cooling system is being topped up. Danger: If, in an exceptionall case, the coolant level has to be checked in an engine that has reached operating temperature, first carefully turn the cap А with safety valve to the first stop, let off pres- sure, then open carefully. Note: Don’t open the cooling system when the engine is at operating temperature. This causes a pres- sure loss in the cooling system.

If the cooling system has been opened when the engine is at operating temperature this can lead to the alarm “pressure in the expansion tank” when the engine is then put into operation and to a reduction in the engine output. Coolant pressure in the expansion tank is only built up again when the engine has cooled down. The cooling system must therefore only be filled up when the engine is cold. Fig. 7 Caution: When the cover is opened with working valves, there is a danger that it is not properly sealed when closed again. The required overpressure is no longer set up in the cooling system. Premature simmer- ing and loss of coolant result.

To avoid damage to the engine, this cover should as a general rule only be opened in excep- tional cases and then replaced by a new one. 7 If the expansion tank needs to be filled up while the engine is at operating temperature, the must be ob- seved: Fig. 8 D To operate the hot engine without alarm again after the end cover has been opened, a pre- pressure of 0.7 bar must be present in the cool- ing system D To achieve this pressure a pressure valve is fitted to the expansion tank. An air pump avail- able on the open market can be connected to this valve. The system must be pumped up to 0.7 bar using this pump. 8 45