MAN — Reassembling coolant pump

Repairing coolant pump Installation note for mechanical seal: Fit the mechanical seal ”wet”, i.e. when fitting, coat holding sleeve Г and coolant pump shaft А with a mix- ture of 50% water and 50% cleaning spirit or 40% to 50% antifreeze as per MAN 324 and water. Other anti-skid agents must not be used. Because the seal on collar Б is coated with sealing paint, no sealing paint needs to be applied if the loca- ting bore in the coolant pump housing is in perfect condition. If the bore shows even the slightest scoring or other minor damage, a sealing bead of Dirko-Transparent, Part No. , must be applied to collar Б .

Fit the seal with a plastic transportation cap onto shaft А and use installation tool Д to press it in until the tool contacts the housing. Remove the plastic cap. 1 2 3 4 5 Note: Tests have shown that most cases of damage to the coolant pump can be attributed to the use of unsuitable coolants. Only those anticorrosion and antifreeze agents expressly approved by MAN Nutzfahrzeuge AG as per the MAN 324 standard (see brochure “Fuels, Lubricants and Coolants for MAN Diesel En- gines”) will guarantee fault-free operation. 54