MAN — Cleaning cooling system

Cleaning cooling system Cleaning inside of cooling system Tests have shown that in many cases the poor condition of the coolant and / or the cooling system ac- counts for damage to the coolant pump seal. The poor condition of the cooling system is normally due to the use of unsuitable or no antifreeze or corrosion inhibitor or to defective caps for filler necks and service valves which are not punctually replaced.

If the coolant pump of an engine develops leaks twice in short succession or the coolant is heavily contami- nated (cloudy, brown, mechanically contaminated, grey or black signs of leakage on the coolant pump hou- sing, after the defect on the oil cooler), clean the cooling system prior to removing the faulty coolant pump as follows: a) Drain coolant b) Open the thermostats positively (use bypass inserts) so that the entire cooling circuit is flushed imme- diately during the cleaning operation c) Fill coolant circuit with a mixture of hot water (min.

50 ° C) and Henkel P 3 neutrasel 5265 detergent (1.5% by volume) (5266, 5225, Kluthe Hakopur 316), refer to Publication “Fuels, Lubricants ...” d) Warm up the engine under load. After a temperature of 60 ° C is reached, run the engine for a further 15 minutes e) Drain cleaning fluid f) Repeat steps c) and d) g) Flush the cooling circuit; to this effect h) Replace the drain plug with a drain plug with an 8 mm dia. bore i) Fill the cooling circuit with hot water k) Run the engine at idle for 30 minutes. At the same time continuously replenish the water emerging for the bore in the drain plug by adding fresh water at the filler neck Only now should the coolant pump be repaired.

On completion of repairs, fill the cooling system with coo- lant, refer to publication “Fuels, Lubricants ...”. Note: Only sediments and suspended particles can be removed by this cleaning method. If rust and lime deposits are detected, proceed following the instructions set out in the section below: 55