Removing and installing flywheel,replacing starter gear ring Replacing starter ring gear Fig. 5 Remove the flywheel. Drill the starter motor toothed wheel and break with a chisel. Caution: In doing so, do not damage the flywheel. Fig. 6 5 Note: As the maximum axial run-out of the starter motor toothed wheel must not be exceeded, the axial run-out of the flywheel should be measured on the contact sur- face of the starter motor toothed wheel prior to shrinking on the starter motor toothed wheel. If the required value is exceeded, replace the flywheel. Engage the flywheel at the hub. Apply the dial gauge to the contact surface of the toothed wheel.
Turn the flywheel a few revolutions by hand and observe the reaction of the dial gauge. 6 Fig. 7 Heat the new starter ring gear to approx. 200 ° C to 230 ° C and press on as far as it will go. Danger: The parts are hot! Risk of burns! Wear protective gloves. Check the axial runout and compare with the max. permissible value. 7 74