Removing and installing flywheel,replacing starter gear ring Removing flywheel D Remove rpm sensor Fig. 1 Release the mounting bolts, securing the engine against rotating if necessary. 1 Fig. 2 Remove two bolts facing each other and replace them by two guide pins (special tool, item 22, see page 189). Remove all the bolts. Pull off the flywheel with suitable lifting gear. Danger: The flywheel is heavy! Use lifting gear. 2 Fitting the flywheel Fig. 3 Insert the guide pins. Coat the sealing face on the inside of the flywheel with “Antipor 46” sealing compound. Place guide mandrels on the flywheel; ensuring that the centering mandrel (arrow) fits correctly into the bore in the flywheel.
Push the flywheel on as far as it will go. 3 Fig. 4 Lightly oil the new mounting bolts (stress bolts), screw them in and tighten in diagonal sequence to specified torque. Tightening torque: Initial torque 100 −110 Nm . . . . . . . . . . . . . . . . . . 1st angle tightening 90−100 ° . . . . . . . . . . . . . . . . 2st angle tightening 90−100 ° . . . . . . . . . . . . . . . . D Install rpm sensor 4 73