MAN — Removing and fitting vibration damper, replacing front crankshaft gasket

Removing and fitting vibration damper, replacing front crankshaft gasket Installing vibration damper Fig. 12 Place vibration damper on two guide pins (M16x1.5). Ensure that the position of the gradua- ted disc relative to the crankshaft is correct. Tighten the mounting bolts with the prescribed tor- que. Tightening torque 260 Nm . . . . . . . . . . . . . . . . . . . 12 Fig. 13 Screw on delivery start indicator and V−belt pul- leys. Refit and tension V-belt (see page 147). 13 Fig. 14 Therefore check whether the scale of degrees on the inspection hole cover of the flywheel housing and on the vibration damper indicate the same va- lues. If necessary readjust delivery start indicator. 14 72