Replacing the bearing race Replacing the bearing race D Removing flywheel, see page 73 Fig. 1 If the shaft sealing ring on flywheel side is repla- ced, it is also recommended to replace the bearing race of the flywheel. Pull off the bearing race to be exchanged using a puller (special tool). 1 Fig. 2 Insert the new bearing race in the drift (special tool) in such a way that the inner bevelled side fa- ces the flywheel when fitted later. Carefully warm up the drift with bearing race. The installation temperature of the bearing race is approx. 150 _ C. 2 Fig. 3 Press in the bearing race as far as it will go. 3 Fig. 4 Seal the gap between flywheel and bearing race with “Antipor 46”. 4 76