Crankshaft seals General information on crankshaft seals As a general principle, the radial shaft sealing rings are made of polytetrafluorothylene (PTFE), otherwise known as Teflon. PTFE sealing rings differ from the elastomer sealing rings that used to be common in that they have a much wider, flat sealing lip that is not pretensioned by a coiled spring expander. The relatively large pretension of the sealing lip itself means that it curves inwards. This is why the PTFE sealing ring is delivered on a transport sleeve. So that it remains possible to mount the sealing ring, it must stay on this sleeve until assembly.
This applies also because the sealing lip is very sensitive and the smal- lest damage causes leaks. The sealing lip and the bearing race of the flywheel must not be coated with oil or other lubricants. On fitting the new sealing ring, always replace the bearing race alongside it. Assembly instructions for crankshaft seals D The PTFE sealing ring must be fitted absolutely free of oil and grease. Even the slightest traces of oil on the bearing race or sealing ring will cause leakage D Remove oil, grease and corrosion inhibitor from the bearing race before assembly. All standard cleaning agents can be used here D If the PTFE sealing ring is fouled with oil or grease, it is rendered unusable.
Cleaning is not permitted in this instance D The PTFE sealing ring must never be stored without the supplied transport sleeve. Even after it has been stored for a period of only 30 minutes without the transport sleeve, it will lose it pretension and thus be rendered unusable 77