MAN — Checking charging pressure

Checking charging pressure Checking charging pressure Sufficient boost pressure is essential to ensuring full power output and clean combustion. Checking the charge-air pressure helps detect damage to the turbocharger, operating faults in the waste- gate and leaks in the intercooler and in the charge-air pipes. Extreme operating conditions (full-load operation and high air temperature) and the use of unsuitable en- gine oils (see also publication “Fuels, Lubricants and Coolants for MAN Diesel Engines”) may give rise to deposits on the compressor and in the intercooler, resulting in a reduction in boost pressure.

Preconditions for measurement The start of fuel delivery and valve clearance must be set as specified and the engine must be at normal operating temperature. Charge-air pressure A general set-point value for the charge-air pressure cannot be given. Values ascertained on the test bed ought not to be used for comparison, as the respective installation conditions are decisive. The value which was ascertained when the ship was commissioned and was noted in the commissioning report is to be used as the set-point value.

When carrying out the measurement, observe the following Based on various atmospheric reference conditions during the measurements and on tolerances of the pressure gauges used, deviations of max. 100 hPa ( 100 mbar) are permitted. Fig. 1 Two measuring connections for checking the charge-air pressure and the charge-air tempera- ture are located in the charge-air elbow behind the intercooler. Remove the screw plug and connect up the pres- sure gauge (M14x1,5 and M12x1,5). 1 Fig. 2 Measure the boost pressure downstream of the intercooler at rated engine speed and full load. 2 83