MAN — Turbocharger, troubleshooting

Turbocharger, troubleshooting If there are abnormal intake or exhaust gas noises Check the intake and exhaust system in the area of the charger group. Defective seals can lead you to think the turbocharger is defective and must therefore be replaced. If there are still unusual noises, check the bearing clearance. Turbochargers in good working order do not make any excessive noise. If oil accumulates in charge-air pipes and intercooler The very design of the engine causes a small amount of oil to collect in the charge-air system in the form of oil mist - this is perfectly natural and desired. The oil mist is required to lubricate the intake valve seats.

If more oil accumulates than is normal, i.e. to the extent that oil pockets develop e.g. in the lower air box of the intercooler, this can lead to oil disintegration or uncontrolled engine racing when the oil is separated. Eliminate the cause in such cases. Possible causes: The engine is overfilled with oil. Check whether the correct dipstick and guide tube combination is fitted. The engine oil used is unsuitable (see publication ”Fuels, Lubricants, Coolants for MAN Diesel Engi- nes”). The engine is being run on impermissibly steep inclines. The crankcase pressure is to high. This may be caused by a defective oil separator valve (crankcare breather) or piston ring wear.

Compressor coking This can occur when the charge-air temperature is permanently high, for example when the engine is con- stantly run at full load. Coking lowers the boost pressure but does not negatively affect power output or acceleration performance. Coking can increase exhaust gas opacity. In the event of compressor coking: Remove the compressor housing without tilting it If it gets jammed, the compressor wheel blades may get damaged or bent, and the resultant imbalance can ruin the turbocharger Remove carbonisation in the compressor housing with a suitable cleaning agent Danger:

Do not under any circumstances spray in cleaning agent while the engine is running Ineffective Risk of accident! In problem cases, use oil types that are less likely to lead to compressor carbonisation (see publication Fuels, Lubricants, Coolants for MAN Diesel Engines”) 82