MAN — Removing and installing cylinder head

Removing and installing cylinder head Fitting the cylinder head Fig. 7 Before fitting, clean and blow out the threaded ho- les in the crankcase. Clean the sealing surfaces on the cylinder head and on the crankcase. Lay the new cylinder head seal in place, ensuring that the hole patterns match up, and place the cy- linder head on top. 7 Fig. 8 Each cylinder head is fixed in position with 2 fitting sleeves. 8 Fig. 9 Check the tappet push rod for deformation. When inserting the tappet push rods, ensure that they fit in the socket of the valve tappet. 1 2 Insert the valve bridges with the cut-through sides Б facing the push rods. 9 Fig.

10 Apply a thin bead of “Loctite 5900” sealing com- pound to seal the rocker arm bearing housing. Caution: The bore hole ( А in Fig. 9) must be kept clear for the oil supply! 10 93