c. CLEANING CAUTION Some commercially available chemical cleaners are caustic. These cleaners may damage plastic parts such as O-rings, float and float valve. Check the container for instructions. If you are in doubt, do not use these products to clean carbu- retor. High air pressure may damage the carburetor. Use low pressure setting when cleaning the pas- sages and parts. 1) Clean the carburetor body, removed parts and float chamber with cleaning solvent. 2) Use low air pressure and blow off the removed jets, nozzles and passages of the carburetor body and float chamber. d.
INSPECTION / ,p==== [l] MOUNTING TAB Float Level Height Place the carburetor as shown and measure the distance between the float top and carburetor body when the float just contacts the seat without compressing the valve spring. Standard float height BF40A: 14 mm (0.55in) BF50A: 13 mm (0.51 in) If the height is out of specification, adjust the float height by bending the float mounting tab carefully. FLOAT GAUGE 37401 -001 0000 FloatlFloat Valve/Float Valve Seat 1) Check the float for crack or damage. Replace if nec- essary. 2) Check the float valve for wear or damage. Replace if necessary. 5-1 1