honda — Fuel System

BF40AoBF50A 4) Insert the air vent tubes into the holes of the engine under case as shown. [l] AIR VENT TUBES CASE 5) Connect the fuel tubes to the fuel pump and secure them with the tube clip B10. I [l] FUEL TUBE (240 mm) Connect the fuel tube E (No. 2 and 3 carburetor supply line) to the I' Q " marked fitting. Connect the 240 mm fuel tube (No. 1 carburetor supply line) to the " 0 " marked fitting. TUBE E 6) Connect the SE thermal valve heater wire 2P connec- tor and set the 2P connector to the lower connector holder, then set the 14P connector to the upper con- nector holder.

[2] 2P CONNECTOR 14PCONNECTOR \ \ \ 7) Insert the breather tube in the silencer cover until the white mark aligns with the hole edge as shown. I r l - 1' 1 BREATHER TUBE [31 SI1 . [2] WHITE .ENCER COVER MARK 5-23