b. ASSEMBLY [l] FRICTION p%EyG\ 1) Install a new friction lever shaft. Turn the friction lever shaft until it stops. 2) Adjust the friction lever shaft direction as shown by turning back the friction lever shaft /4 - 314 turn. 3) Before installation, check the disc surface of the fric- tion discs for wear. Replace if necessary. [l] FRICTION DISC 4) Clean off grease or oil from the disc surfaces of the friction discs and friction plate. Install one of the fric- tion disc onto the friction lever shaft by aligning the cutout with the boss on the swivel case and facing the disc surface toward the friction plate as shown.
131 CUTOUT 5) Install the friction plate to the mount frame by aligning the groove with the friction lever shaft and loosely install the two 6 x 12 mm flange bolts. 11 1 \ FRICTION PLATE 6 x 12 (2) 6) Push the friction plate toward the mount frame in the direction shown by arrow and tighten the 6 x 12 mm flange bolts securely. 121 MOUNT FRAME [l] FRICTION PLATE \ i \ I I I \ [2] MOUNT FRAME 12-2