shaft by aligning the cutout with the boss on the swiv- el case and facing the disc surface toward the friction plate. I \ 8) Install the 8 mm nylon washer, friction adjusting lever and 8 mm washer. [I1 [2] 8 mm 9) Turn the adjusting lever to the left side fully, and hold it in this position and tighten the 8 mm self-locking nut to the specified torque. ADJUSTING LEVER NUT FRICTION SELF-LOCKING \ / I I \ TORQUE: 9.5 N*m (0.95 kgf*m, 6.9 Ibfoft) 141 8 mm NYLON WASHER - I/- // 131 8 mm WASHER 10) Check the starting torque by measuring the starting force using a spring scale at the center of the throttle grip (P. 3-8). [5] FRICTION ADJUSTING LEVER 1213