honda — Gas Assisted/Power Tilt

13. GAS ASSISTED/POWER TILT 1. GAS ASSISTED DAMPER 2. POWER TRIMnILT ASSEMBLY I 1. GAS ASSISTED DAMPER a. REMOVAL Drain the carburetor by loosening the drain screws. Gasoline is highly flammable and explosive. You can be burned or seriously injured when handling fuel. Keep heat, sparks, and flame away. Handle fuel only outdoors. Wipe up spills immediately. Lay the outboard motor on its right side (carburetor side). [l] 10 x 158 mm 121 TRANSOM ANGLE ADJUSTING ROD Raise the outboard motor to the uppermost position and set the tilt stopper to the RUN position. Remove the 10 mm E-ring from the upper cylinder pin, and then remove the upper cylinder pin.

6 mm PLAIN Remove the upper mount of the gas-assisted damper from the swivel case. Remove the upper cylinder bushings if necessary. Replace with new ones when the upper cylinder busings are removed. Remove the transom angle adjusting rod. - [3] 10 mm PLAIN WASHER [6] 6j25 mm [5] [4] 10 mm HEX. ANODE SELF-LOCKING BOLT (2) METAL NUT Remove the 6 x 25 mm hex. bolts, 6 mm plain wash- ers and anode metal. Remove the 10 mm self-locking nut and remove the 10 mm plain washer and 10 x 158 mm hex. bolt. 10) Loosen the 7/8-14 UNF self locking nut. 11 1 7/8-14 UNF SELF-LOCKING NUT 13-1