BF40AoBF50A 11) Lift the left stern bracket and remove the gas assisted damper. Make sure that the tilt lever is in "RUN" position before removal. Store the gas assisted damper with fully extended position 12) Remove the 26 mm wave washer and 10 mm dis- tance collar. 13) Remove the lower cylinder bushings if necessary. Replace with new ones when the lower cylinder busing is removed.
11 1 10 mm DISTANCE COLLAR [2] GAS ASSISTED ' \ DAMPER LOWER CYLINDER BUSHING (2) [3] 26 mm WAVE WASHER 141 p x E i q *TILT LEVER REPLACEMENT Before removing the tilt lever, set the tilt lever in the "RUN" position Install the tilt lever by aligning the mounting hole of the lever with the tilt lever shaft and noting the installation direction as shown. 1 [41 / TILT LEVER \ [31 6 mm SELF-LOCKING NUT 1 12 N*m (1.2 kgf*m, 9 Ibf*ft) 1 13-2