honda — Gas Assisted/Power Tilt

BF40AoBF50A b. DISPOSAL 1) Set the tilt lever in the "TILT" position with the piston rod fully extended, then remove the tilt lever. 2) Wrap the damper inside a plastic bag and support the damper in a vice as shown. 3) Through the open end of the plastic bag, insert a drill motor with a sharp 2 - 3 mm (5/64 - 1/8 in) drill bit. 11 1 PLUG CAUTION The gas assisted damper contains nitrogen gas and oil under high pressure. Do not drill past the reservoir top, or you may drill into the oil chamber; oil escaping under high pressure may cause serious personal injury.

Do not use a dull drill bit which could cause a build-up of excessive heat and pressure inside the damper, leading to explosion and severe personal injury. Always wear eye protection to avoid getting metal shaving in your eyes when the gas pres- sure is released. The plastic bag is only intend- ed to shield you from the escaping gas. 4) Hold the bag around the drill motor and briefly run the drill motor inside the bag; this will inflate the bag with air from the drill motor and keep the bag from getting caught in the bit when you start. 5) Drill the plug bolt on the reservoir top. 13-3