honda — Gas Assisted/Power Tilt

BF40AoBF50A 2. POWER TRlMITlLT ASSEMBLY a. REMOVAL Drain the carburetor by loosening the drain screws and remove the motor from the engine. Gasoline is highly flammable and explosive. You can be burned or seriously injured when handling fuel. Keep heat, sparks, and flame away. Handle fuel only outdoors. Wipe up spills immediately. Lay the outboard motor on its right side (carburetor side). [l] MAIN WIRE HARNESS I 6x12 / GROUND TERMINAL \ Raise the outboard motor to the uppermost position and set the tilt stopper in the TILT position. Remove the engine cover and CDI unit cover (see base shop manual). Pull the fuse holder from the fuse holder bracket.

Remove the 6 x 12 mm flange bolt and main wire har- ness ground terminal. 131 FUSE Remove the 6 x 25 mm flange bolt, 6 mm plain wash- er and fuse holder bracket. [l] CDI UNIT CASE Remove the CDI unit case mounting three 6 x 25 mm flange bolts and 6 mm plain washers, then pull out the CDI unit case slightly from the engine. 6i28 \ 6 mm PLAIN WASHER (3) [3] FUSE HOLDER BRACKET 13-5