honda — Gas Assisted/Power Tilt

BF40AoBF50A 9) Disconnect the power trimhilt motor wire 2P connec- tor. 'CONNECTOR rn 10) Pull off the trim angle sensor's three connectors from the connector holder and disconnect them. I [l] CONNECTOR HOLDER [2] CONNECTORS I SENSOR WIREY \ 11) Unfasten the purse lock clip und pull out the trim angle sensor wire through the hole of the CDI unit case. SENSOR WIRE 12) Loosen the rivet screw and remove the 14 mm clip. 13) Remove the upper case grommet C from the engine under case and pull the power trimhilt motor and trim angle sensor wires from the engine under case. TRIM ANGLE SENSOR WIRE GROMMET 13-6