BF40AoBF50A 14) Remove the spiral protector, and open the wire har- ness clip and unfasten the power trimhilt motor wire and trim angle sensor wire. [I 1 [2] WIRE HARNESS CLIP 15) Remove the motor cord bushing from left stern brack- et. TRl W I L T MOTORAND 0 TRIMANGLE \ \ CORD BUSH IN G SENSOR WIRES 16) Remove the transom angle adjusting rod. 17) Remove the 6 X 25 mm hex. bolts, 6 mm plain wash- ers and anode metal. PI TRANSOM ADJUSTING ROD \ \ [3] 6 mm PLAIN WASHER (2) [4] 6 x 25 mm HEX. BOLT (2) 18) Remove the 10 mm E-ring from the upper cylinder I 113 10 mm E-RING (2)\ 19) Remove the upper mount of the power trimhilt from pin, and then remove the upper cylinder pin. the swivel case.
20) Remove the upper cylinder bushings if necessary. Replace with new ones when the upper cylinder busing is removed. CYLINDER PIN I BUSHING 13-7