honda — Gas Assisted/Power Tilt

2) After installing the power trim/tilt assembly, tighten the 7/8-14 UNF self-locking nut to the specified torque. Then turn it back 1/2 - 3/4 turns. 11 1 7/8-14 UNF SELF- LOCKING NUT, I TORQUE: 39 N*m (4.0 kgfom, 29 Ibfoft) 3) Route the power trim/tilt motor and trim angle sensor wires and secure them with the clips. [l] WIRE HARNESS CLIP [2] PURSE LOCK CLIP Clamp the trim angle sensor wire together with the power trimhilt switch wire and power trimhilt relay wires as shown.

trim/tilt switch wire, power trimhlt relay wires, and trim 151 TRIM ANGLE SENSOR WIRE [3] POWER TRIMITILT’ /--A/ I MOTOR WIRE [3] POWER TRIMITILT [9] 14 mm TUBE CLIP MOTOR WIRE 141 (( TRIM ANGLE SENSOR Clamp the center of the gray tape position of the power trimhilt motor wire with the wire harness cliD. , I SPIRAL PROTECTOR angle sensor wires, wrap the wires between the 14 mm TRIM ANGLE SENSOR WIRE POWER TRIMITILT MOTOR WIRE [6] MOTOR CORD BUSHING 13-1 0