BF40A-BF50A 4) Set the trim angle sensor wire connectors on the con- nector holder. [11 PI 6 mm PLAIN WASHER / CDI UNIT CASE 5) Set the CDI unit case in the place and install the 6 mm plain washers and 6 x 25 mm flange bolts, and tighten the bolts securely. 6) Install the fuse holder bracket with the 6 x 28 mm flange bolt, then install the fuse holder. [71 \ FUSE HOLDER BRACKET [3]BLACK LIGHT GREEN/ YELLOWlBLUE TRIM ANGLE SENSOR WIRE 7) Set the ground terminal as shown and tighten the 6 x 12 mm flange bolt securely noting the terminal direc- tion. PI GROUND TERMINAL \ ‘6x12 13-1 1