honda — Throttle Bracket/Shift Lever/Handlebar (Tiller Handle Type Only)

BF40AoBFSOA Apply grease to the inside of the throttle grip pipe, inside of the friction grip, both ends of the throttle cable pin, handle pipe and both sides of the friction pad. Set the throttle friction pad on the grip pipe. [l] BOSS Install the grip pipe on the tiller handle by slowly turning it clockwise. FRICTION DISC 4---- [7] (Inside.) [7] (Inside.) A> 161 CUTOU PIPE 7 \\ FRICTION PAD FRICTION PAD 151 THROTTLE FRICTION GRIP Tighten the throttle friction grip against the thrqttle fric- tion disc by aligning the cutout of the friction pad with the boss of the friction disc. Tighten the 6 x 12 mm flange bolt securely.

Turn the grip pipe to the fully close position and install the grip rubber by aligning the "A" mark with fully close mark. ~~ [2] THROTTLE FRICTION GRIP \ / 11 1 GRIP PIPE [41 GRIP RUBBER 6x12 [31 "A" mark 15-1 7