honda — Throttle Bracket/Shift Lever/Handlebar (Tiller Handle Type Only)

BF40A-B F50A *TILLER HANDLE WIRE HARNESS r11 10 - 20 mm % (0.4 - 0.8 in) % Connect connectors to the wire connectors of the same color, cover the connectors with the connector covers and secure them with the harness band clip. Replace the wire band with a new one, if it has been cut. After securing the connectors and wires with a new wire band, cut the end of the wire band so the project- ed end length is 10 - 20 mm (0.4 - 0.8 in). Install the tiller handle wire harness by aligning the wire tie with the grommet as shown 4- WIRE BAND CLIP [4] GROMMET Power Tri mni It Type:

r71 - F + EMERGENCY STOP SWITCH WIRE \ \ * CONNECTOR r81 COVER B 121 r31 \ [6] WIRE BAND CLIP (3) TILLER HANDLE WIRE TIE WIRE HARNESS L r51 POWER TRIM/TILT \ 11 41 CONNECTOR COVERA \ 15-1 9