BF40AoBF50A 10) Hold the bottom piece in a vise with shop towel or soft jaws as shown and loosen the outer tube using the lock nut wrench, then remove the cylinder/piston assembly from the vise. (s.TooII) [l] LOCKNUT WRENCH 30 x 40 0791 6-9690000 CAUTION: Take care not to tighten the vise too tight as it damages the bottom piece. BOTTOM PIECE 11) Remove the outer tube by loosening the outer tube slowly, and drain the residual ATF from the outer tube and cylinder. Remove the O-ring from the outer tube using a small screw driver taking care not damage the O-ring instal- lation section, and discard the O-ring. Replace the 0- ring with new one during reassembly.
Clean the threads of the outer tube. 1 ~ o n o t reuse. 1 13-6