honda — Print

9) Prepare a piece of piano wire of 1.5 mm in diameter as shown. [l] About 50 m m (1 .O in) i.--------------i 7) Set the prepared wire in the holes in both sides of the sleeve as shown, and secure the wire by inserting the 10 mm bolt into the sleeve. Remove the sleeve from the valve body by pulling the wire with care not to damage the valve body. Remove the O-ring from the sleeve and discard it. Replace the O-ring with a new one during reassembly. 3 - 4 mm (0.12 - 0.15 in) I [2] PIANO WIRE [3] 10 m m BOLT [4] SLEEVE [5] O-RING Do not reuse. 8) Set the valve body as shown. Apply small squirt of air pressure to the manual valve installation hole to remove the valve B.

Remove the valve B from the valve body. [l] O-RING [2] VALVE B Remove the O-ring from the valve B. Replace the 0- ring with a new one during reassembly. [2] VALVE B 13-1 0