honda — Print

f. BLOW PRESSURE INSPECTION After reassembling the power trim/tilt assembly, per- form the blow pressure inspection. Install the power trimhilt assembly after the blow pressure inspection. [l] For lower chamber side [s.TooJ GAUGE JOINT A 07OPJ-V150100 Before blow pressure inspection, perform the following: - Connect each engine side wire and motor 2P con- nector so that the power trimhilt assembly can oper- ate while it is isolated from the outboard motor. Remove the power trim/tilt assembly if it is mounted. - Extend the piston rod of the power trim/tilt assembly fully after operating (moving up and down) the pis- ton rod several times.

[2} For upper chamber side [S.] GAUGE JOINT B 07OPJ-V150200 - Check ATF level in the power trimhilt assembly oil tank. It must be at the specified level (P. 13-28). - Perform the cylinder upper chamber side and lower chamber side blow pressure inspection using the special tools and commercially available pressure gauge. - Use the pressure gauge which measures 40 MPa (400 kgf/cm2, 5,600 psi) or above with P/F 1/4 thread. LOWER CHAMBER SIDE BLOW PRESSURE 1) Remove the internal circlip, manual valve and sealing washer from the valve body. Install the special tool (gauge joint body B) and the sealing washer, and tighten the special tool to the specified torque. INTERNAL ClRCLlP TORQUE:

1.7 N*m (0.17 kgf*m, 1.2 Ibf*ft) Be sure to remove the manual valve with the piston rod fully extended, or ATF spurts out. A small amount of ATF flows out after removing the valve. Install the special tool quickly. Install the sealing washer securely not to let it col- lapse in the valve body. 2) Attach a commercially available pressure gauge to the special tool that is set in the valve body. 07OPJ-V150200 [51 PRESSURE GAUGE / (Commercially available) 3) Be sure that ATF level in the oil tank is at the speci- fied level (P. 13-28). 13-29