BF40AoBFSOA 9) Hold the power trimhilt assembly upright and bring the oil level to the lower edge of the oil filler port. Loosely tighten the oil hole cap. ’OLE \ it 10)Move the piston rod from the fully compressed posi- tion to the fully extended position two or three times by operating the power trimhilt switch. 11)Push the side of the power trim/tilt switch again to extend the piston rod fully. 12) Remove the oil cap bolt and check the oil level. If the level is low, add ATF with a syringe or equivalent tool until ATF flows out of the oil filler port. 11 3IL FILLER 13) Install the new O-ring on the oil cap and tighten the oil cap to the specified torque.
121 OIL LEVEL (LOWER EDGE OF OIL FILLER HOLE) TORQUE: 0.8 N*m (0.08 kgfom, 0.58 Ibf*ft) 14) Wipe up ATF spilled from the cylinder comp. thor- oughly. Operate the power trimhilt switch and check that the piston rod moves smoothly. Ib 15) Check the blow pressure (P. 13-29). [31 O-RING [4] OIL HOLE CAP 0.8 N-m (0.08 kgfom, 0.58 Ibfoft) e. UPPER JOINT METAL INSTALLATION 1) Apply LOCTITEa 271 or equivalent to the thread of [l] UPPER JOINT METAL the piston rod. 2) Install the upper joint metal against the piston rod. 3) Holding the piston rod and tighten the upper joint metal to the specified torque. TORQUE: 44 N*m (4.5 kgf*m, 33 Ibfaft) 13-28