BF40AoBFSOA 6) Clamp the motor wire to the motor cord bracket A with the wire band. [l] WIRE BAND CLIP (2) [2] MOTOR CORE After securing the wires with a new wire band , cut the end so projected end length is 3 - 5 mm (0.1 - 0.2 in). 7) Set the wire band clips on the clip bracket B, and secure the motor wire with them. After securing the wires with new wire band clip, cut the end so projected end length is 3 - 5 mm (0.1 - 0.2 in). [4] WIRE BAN 131 MOTOR CORE BRACKET A d. AIR BLEEDING [l] OIL FILLER HOLE 1) Lay the power trimhilt assembly on its side with the oil filler port facing up.
\ 2) Connect the battery, power trimhilt relay and the power trimhilt switch so that the power trim/tilt assem- bly functions while it is dismounted from the outboard motor. 3) Check that the manual valve is loose. Using a syringe or equivalent tool, pour ATF in the oil tank slowly to fill it up. / [2] OIL TANK 4) After filling the oil tank, tighten the manual valve securely. Check that the oil hole cap bolt is not installed. 5) Push the side of the power trimhilt switch to extend the piston rod fully. While extending the piston rod, pour ATF into the oil tank to keep the oil level in the oil tank at full level.
6) Push the “DW” side of the power trimhilt switch to compress the piston rod fully. Do not tighten the oil hole cap bolt this time. Let ATF flow out of the oil filler port. 7) Repeat the above steps 5 and 6 three to five times. Repeat this procedure until the piston rod moves smoothly. 8) After the piston rod moves smoothly, push the side of the power trimhilt switch again to extend the piston rod fully. While extending the piston rod, pour ATF into the oil tank to keep the oil level in the oil tank at full level. 13-27