BF40A-BFSOA MOTOR INSTALLATION [l ] DRIVE JOINT / 1) Install the drive joint in the position of the gear pump assembly as shown. I [2] GEAR PUMP ASSEMBLY 2) Apply ATF to a new O-ring, and install it on the power trimhilt motor assembly. [l ] OIL FILLER HOLE ,I PI 3) Fill the gear pump chamber with the fresh ATF up to the upper edge of the chamber. If ATF in the valve body contains air bubbles, remove the air bubbles using an oil bottle or equivalent tool. Do not pour ATF into the valve body gear pump chamber quickly. Pour the fluid slowly. Trapped air in the system causes faulty operation. Remove the air bubbles in the fluid completely.
4) Install the power trimhlt motor assembly on the valve body so that the motor wires is at the oil filler port on the oil tank and align the motor shaft with the groove of the drive joint as shown. MOTOR O-RING 2.4x66.6 mm 5) Set the motor cord bracket A as shown and tighten the four screw washers to the specified torque. [l] SCREW WASHER (4) TORQUE: 6.4 N o r n (0.65 kgfom, 4.7 Ibfoft) MOTOR CORD BRACKET A 13-26