honda — Print

1) Apply grease to the oil seal lip. Check the oil seal lip.lf the oil seal lip is damaged, replace the front bracket as assembly. A [l] ARMATURE 2) Expand the brushes and install the armature taking care not to damage the oil seal. Remove the burrs at the armature shaft with a fine emery paper before assembly. Make sure that the brush springs are in place PI BRUSH I I SPRING 151 FRONT BRACKET USHES [4] OIL SEAL LIP 3) Apply grease to a new motor O-ring and install it on the front bracket. [l] 5 x 20 mm SCREW (3) ,[2]YOKE 4) Make sure there is no metallic part (e.g. washer, etc.) on the magnets before installation. 5) Apply grease to the yoke side end of the armature shaft.

Hold the armature shaft and install the yoke. 6) Tighten the three 5 x 20 mm screws to the specified torque. TORQUE: 2.2 N*m (0.22 kgfom, 1.6 Ibfoft) 7) After assembly, lightly tap on the outer surface of the yoke with a plastic hammer (for snug fitting of the armature bearing). [3] MOTOR O-RING - pGGGJ 13-25