honda — Print

POWER TRIM/TILT MOTOR 9 Make sure there is no metallic part (e.g. washer, etc.) on the magnets before installation. After installing the yoke, lightly tap on the outer sur- face of the yoke with a plas- tic hammer (for snug fitting of the armature bearing). , \ [2]5 mm SCREW(3) 2.2 N m, (0.22 kgf m, 1.6 Ibf *ft) / [S] ARMATURE Remove the burrs at the armature shaft with a fine emery paper before assem- bly. Take care not to damage the oil seal during assem- bly. [5] FRONT BRACKET ASSEMBLY 13-24