25)Tighten the outer tube guide to the specified torque using the lock nut wrench. TORQUE: 88 N*m (9.0 kgf*m, 65 Ibf*ft) (S.] LOCK NUT WRENCH 070PA-ZW40100 26)Tighten the manual valve securely. 121 OUTER TUBE GUIDE 27)Apply rubber grease or ATF to a new oil seal.Holding the oil seal with your fingers so that it shapes and install it in the groove in the outer tube taking care not to damage the oil seal. [2] Push in by deform- PI Push in aslant. ing it lightly. [l] OIL SEAL 0 28)Apply ATF to new O-ring and install it on the outer tube guide. 0 141 Hold in the shape 29)Apply ATF to the piston rod and install the oil tank by turning it taking care not to damage the oil seal in the oil tank.
[5] 5 mm SOCKET BOLT (4) 14.7 N*m, (0.48 kgf*m, 3.5 Ibf*ft) 1 30)Set the oil tank as shown and tighten the four 5 mm socket bolts to the specified torque. - 161 OILTANK TORQUE: 4.7 N*m (0.48 kgfem, 3.5 Ibf*ft) 31)Remove the sealing tape from the top end of the pis- ton rod. ~ DO not reuse. I 13-23