Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

105 Operation Section Engine Starting (Alternate Methods) SEBU7645-06 Note: The batteries are connected in series. Use the terminal that is connected to the starter solenoid. This battery is normally on the same side of the machine as the starter. 9. Connect the positive jump start cable to the positive terminal of the electrical source. Use the procedure from Step 8 in order to determine the correct terminal. 10. Connect one end of the negative jump start cable to the negative terminal of the electrical source. 11. Make the final connection. Connect the negative cable to the frame of the stalled machine.

Make this connection away from the battery, the fuel, the hydraulic lines, or moving parts. 12. Start the engine on the machine that is the electrical source. Also, you can energize the charging system on the auxiliary power source. 13. Allow the electrical source to charge the batteries for two minutes. 14. Attempt to start the stalled engine. Refer to Operation and Maintenance Manual, “Engine Starting’. 15. Immediately after the stalled engine starts, disconnect the jump start cables in reverse order. 16. Conclude with a failure analysis on the starting charging system. Check the stalled machine, as required.

Check the machine when the engine is running and the charging system is in operation.