Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

121 Maintenance Section Bucket Cutting Edges - Inspect/Replace SEBU7645-06 Test the brakes on a dry, level surface. Fasten the seat belt before you test the brakes. The following tests are used to determine if the parking brake is functional. These tests are not intended to measure the maximum brake holding i01920076 Bucket Cutting Edges Inspect/Replace - SMCS Code: 6801-040; 6801-510 effort. The brake holding effort that is required to sustain a machine at a specific engine rpm varies depending on the machine. The variations are the differences in the engine setting, in the power train efficiency, and in the brake holding ability, etc. 1. Start the engine. Raise the bucket slightly.

Personal injury or death can result from bucket falling. Block the bucket before changing edges. bucket cutting 2. Engage the parking brake. 3. Move the transmission control lever to THIRD SPEED FORWARD, to NEUTRAL, and back to THIRD SPEED FORWARD. This is done in order to override the transmission neutralizer for this test. Note: The parking brake indicator light should come on and the parking brake alarm should sound. 4. Gradually increase the engine speed to high idle. The machine should not move. 1. Raise the bucket. Place a block under the bucket. 2. Lower the bucket to the blocking. Do not block up the bucket too high.

Block up the bucket so that the bucket is high enough to remove the cutting edges and the end bits. 3. Remove the bolts. Remove the cutting edge and the end bits. 4. Clean the contact surfaces. 5. Use the opposite side of the cutting edge, if this side is not worn. lf the machine begins to move, reduce the engine speed immediately and apply the service brake pedal. 5. Reduce the engine speed. Move the transmission to NEUTRAL. Lower the blade to the ground. Stop the engine. 6. Install a new cutting edge, if both edges are worn. 7. Install the bolts. Tighten the bolts to the specified torque. 8. Raise the bucket. Remove the blocks. 9. Lower the bucket to the ground.

NOTICE if the machine moved while testing the brakes, contact your Caterpillar dealer. Have the dealer inspect and, if necessary, repair the parking brakes before returning the machine to operation. 10. After a few hours of operation, check the bolts for proper torque.