Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

120 Maintenance Section SEBU7645-06 Braking System - Test 2. Remove the inspection port plugs on the rear axle. 3. Insert a 221-6893 Brake Wear Gauge for 924G and 924Gz Check the area around the machine. Make sure that the machine is clear of personnel and clear of obstacles. machines that are equipped with a single brake disc. Insert 221-6894 Brake Wear Gauge for 924G and 924Gz machines that are Make sure that the steering frame lock link is in the stored position. equipped with dual brake discs. Insert 221-6892 Brake Wear Gauge for 928G and IT28G machines. Test the brakes on a dry, level surface. Measure the thickness of the brake disc.

Refer to the following table in order to determine the remaining brake disc life according to disc thickness. Table 59 FRICTION DISC WEAR Fasten the seat belt before you test the brakes. The following tests are used to determine if the service brake is functional. These tests are not intended to measure the maximum brake holding effort.

The brake holding effort that is required to sustain a machine at a specific engine rpm varies CHART Percent of Remaining Life Thickness of the Friction Disc 100 7.80 mm (0.31 inch) 90 7.65 mm (0.30 inch) 80 7.51 mm (0.30 inch) 70 7.36 mm (0.29 inch) 60 7.22 mm (0.29 inch) 50 7.07 mm 40 6.92 mm (0.27 inch) 30 6.78 mm (0.27 inch) 20 6.63 mm (0.26 inch) 10 6.47 mm (0.26 inch) 0 6.34 mm (0.25 inch) (0.28 inch) depending on the machine. The variations are the differences in the engine setting, in the power train efficiency, and in the brake holding ability, etc. 1. Start the engine. Raise the bucket slightly. 2. Apply the service brake. Release the parking brake. 3.

Press the top of the transmission neutralizer override switch. 4. Move the transmission control lever to THIRD SPEED FORWARD while the AUTO shift switch is in the OFF position. 5. Gradually increase the engine speed to high idle. _ The machine should not move. 6. Reduce the engine speed to low idle. Move the transmission to NEUTRAL. Engage the parking brake. Lower the blade to the ground. Stop the 4. Install the inspection port plugs. Consult your Caterpillar dealer for the replacement engine. of brake discs. NOTICE If the machine moved while testing the brakes, contact 100058445 Braking System - Test SMCS your Caterpillar dealer.

Have the dealer inspect and, if necessary, repair the service brake before returning the machine to operation. Code: 4011-081; 4267-081 Service Brake Holding Ability Test Refer to the Operations and Maintenance Manual, “Disk Brakes - Inspect” for the requirements of the disc thickness. Secondary Personal injury can result if the machine moves while testing. If the machine begins to move during test, reduce the engine speed immediately and engage the parking brake. Brake Holding Ability Test Check the area around the machine. Make sure that the machine is clear of personnel and clear of obstacles. Make sure that the steering frame lock link is in the stored position.