119 Maintenance Section Brake Accumulator - Check SEBU7645-06 2. Start the engine. Run the engine at half speed for two minutes in order to increase the accumulator pressure. The alert indicator for brake oil pressure should go off. 3. Stop the engine. Apply the service brake pedal and release the service brake pedal until the alert indicator for brake oil pressure comes on. This will decrease the accumulator pressure. A minimum of five applications of the service brake pedal are required. Hlustration g00912373 121 3. Loosen compressor bracket mounting bolt (4). Loosen adjusting locknut (3). 4. Move the compressor until the correct belt tension is reached. 5.
Move the compressor until the correct belt tension is reached. Tighten adjusting locknut (3). Tighten the compressor bracket mounting bolt (4). 4. lf the alert indicator comes on after less than five applications of the brake, measure the accumulator precharge pressure. An authorized Caterpillar dealer can measure the nitrogen gas pressure in the accumulator. Use only dry nitrogen gas for recharging. 102158515 Brake Discs - Check SMCS Code: 4255-535 Inspect the Wear of Brake Discs 6. Recheck the belt deflection. If the amount of deflection is incorrect, repeat Step 3 to Step 5. 7. Start the engine. If poor cooling is still experienced, turn off the air conditioner. Stop the engine.
Notify your Caterpillar dealer for air conditioner system service, if necessary. 101792954 Brake Accumulator SMCS Code: - Check 4263-535 INustration 123 g00614322 1. Remove the inspection port plugs on the front axle. Illustration 122 g00917016 1. Turn the engine start switch to the ON position. The alert indicator for brake oil pressure should come on if the braking system is not at normal operating pressure. Illustration 124 g00101853