Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

136 Maintenance Section Engine Air Filter Primary Element - Clean/Replace SEBU7645-06 Apply lubricant to the grease fitting that is on the drive shaft support bearing. 102310346 Engine Air Filter Primary Element - Clean/Replace SMCS Code: 1054-070-PY; 1054-510-PY The primary air filter element is located in the engine compartment. NOTICE Never service the air cleaner when the engine is running, to avoid engine damage. 1. Remove the air cleaner housing cover (1). 2. Remove the primary filter element (2) from the air NOTICE Caterpillar recommends certified air filter cleaning services that are available at Caterpillar dealers.

The Caterpillar cleaning process uses proven procedures to assure consistent quality and sufficient filter life. Observe the following guidelines clean the filter element: g00101864 lilustration 164 if you attempt to Do not tap or strike the filter element in order to remove dust. Do not wash the filter element. Use low pressure compressed air in order to remove the dust from the filter element. Air pressure must not exceed 207 kPa (30 psi). Direct the air flow up the pleats and down the pleats from the inside of the filter element. Take extreme care in order to avoid damage to the pleats. Do not use air filters with damaged pleats, gaskets, or seals.

Dirt entering the engine will cause damage to engine components. Service the air cleaner filter element when the yellow piston on the engine air filter service indicator enters the red zone. Refer to Operation and Maintenance Manual, “Engine Air Filter Service Indicator - inspect’. Refer to Operation and Maintenance Manual, “Engine Air Filter Secondary Element - Replace’. cleaner housing. When you use pressure air, the maximum pressure is 207 kPa (30 psi). air a. When you clean the inside pleats and the outside pleats, direct the air along the pleats. b. inspect the filter elements after you clean the filter elements. Do not use a filter if the pleats, the gaskets or the seals are damaged.

c. Reset the engine air filter service indicator. Replace the primary element after the primary element has been cleaned six times. Also replace the primary element if the primary element has been in service for one year. 3. Install a clean filter element and install the cover. 101778246 Engine Air Filter Secondary Element - Replace SMCS Code: 1054-510-SE NOTICE Always replace the secondary attempt to reuse it by cleaning. filter element. Never The secondary filter element should be replaced at the time the primary element is serviced for the third time.

The secondary filter eiement shouid aiso be repiaced if the yellow piston in the filter element indicator enters the red zone after installation of a clean primary element, or if the exhaust smoke is still black.