Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

135 SEBU7645-06 Maintenance Section Drive Shaft Spline (Center) - Lubricate Refer to Special Publication, SEBU6250, “Caterpillar Machine Fluids Recommendations’, “S-O-S Oil Analysis” for information that pertains to obtaining an oil sample. Refer to Special Publication, PEHP6001, “How To Take A Good Oil Sample” for more information about obtaining an oil sample. Drive Shaft Spline (Center) Lubricate Code: Drive Shaft Support Bearing Lubricate : SMCS Code: 3253; 3267-086-BD 101700983 SMCS i01778099 Wipe the grease fitting before you lubricate the grease fitting. 3253-086 Wipe the grease fitting before you lubricate the grease fitting.

NOTICE To prevent darnage to the seal, fully articulate the machine to the right or to the left, before lubricating the spline. 1. Start the engine. Raise the bucket. Release the parking brake. Fully articulate the machine to the IHustration 161 g00616283 left or to the right. 2. Lower the bucket to the ground. Engage the parking brake. Stop the engine. IHustration 162 g00909201 924G/924Gz lustration 160 g00616221 3. Apply lubricant to the grease fitting that is on the drive shaft spline. 4. Start the engine. Raise the bucket. Release the parking brake. Articulate the machine until the machine is straight. 5. Lower the bucket until the bucket exerts a slight downward pressure on the ground.

Stop the engine. Engage the parking brake. Illustration 163 928GNT28G g00616286