138 Maintenance Section Engine Air Precleaner - Clean SEBU7645-06 Start the engine. Run the engine at high idle. If the yeilow piston in the filter service indicator enters the red zone, service the air cleaner. Stop the engine. 101701038 Engine Air Precleaner - Clean (lf Equipped) 102356267 Engine Crankcase Breather Clean SMCS Code: 1317-070 Open the engine access door on the right side of the machine. SMCS Code: 1055-070 Iltustration 172 Illustration 170 900616353 Use the ladder (1) and the platform (2) in order to access the precleaner bowl (3). The ladder and the platform are located on the right side of the machine. 1. Empty the precleaner bow! whenever the dirt reaches the “FULL” mark.
goo909608 The breather is located below the air cleaner on the side of the valve cover. 1. Loosen the breather outlet hose clamp (1). Remove the breather hose (2) from the valve cover. 2. Remove the valve cover. 3. Check the condition of the cover seal. If the used seal is damaged, replace the seal with a new seal. 4. Wash the element in a clean, nonflammable solvent. Wash the valve cover in a clean, nonflammable solvent. 5. Shake the element in order to dry the element. Pressure air may also be used to dry the element. 6. Inspect the breather hose for damage. the breather hose, if necessary. Iilustration 171 g00616354 2. Loosen the wing nut on the cover and remove the cover. 3.
Empty the precleaner bowl. Wash the precleaner bowl and wash the cover. 4. Install the precleaner bowl and install the cover. Tighten the wing nut until the wing nut is only finger tight. Do not use a tool to tighten the wing nut. Replace 7. Install the breather element. Install the valve cover. 8. install the breather hose and the breather outlet hose clamp. 9. Close the engine access door,