Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

153 Maintenance Section Tire Inflation - Check SEBU7645-06 Apply lubricant to the grease fitting for the head end of the steering cylinder. 8 g00627 182 IHustration 216 g00913018 Hlustration 214 Apply lubricant to the two remote grease fittings for the rod ends of both steering cylinders. Tire Inflation - Check Code: 3. Remove the magnets from the housing. 4, Remove the screen from the housing. 102154685 SMCS 2. Remove the magnetic strainer cover. 5. Wash the tube and the screen in a clean, nonflammabie solvent. NOTICE 4203-535-Al Do not drop or rap the magnets against any hard ob- jects. Replace any damaged magnets. 6.

Clean the magnets with a cloth, with a stiff bristle brush, or with pressure air. 7. Install the magnets and the tube assembly into the magnetic screen. 8. Install the magnetic screen. 9, Clean the cover and inspect the seal. Replace the seal, if the seal is damaged. 900474937 Itustration 215 Measure the tire pressure on each tire. Consult your Caterpillar dealer for the correct load rating and for . the correct operating pressures. Inflate the tires, if necessary. See Operation and Maintenance Manual, “Tire Inflation Information’. 101733850 Transmission Magnetic Screen - Clean 10. Install the cover. Tighten the cover bolts. 11. Fill the transmission.

See Operation and Maintenance Manual, “Transmission Oil - Change”. 101733855 Transmission Oil - Change SMCS Code: 3030-044 Operate the machine for a few minutes in order to warm the transmission oil. SMCS Code: 3030-070-MGS; 3030-535-MGS; 3030 The machine should be level. Lower the bucket to the ground and apply slight downward pressure. Engage 1. Drain the transmission oil. See Operation the parking brake and stop the engine. and Maintenance Manual, Change”. “Transmission Oil -