Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

154 Maintenance Section SEBU7645-06 Transmission Oil - Change ilustration 217 g00627260 1, Remove the transmission drain plug. Allow the transmission oil to drain into a suitable container. Clean the transmission drain plug and install the transmission drain plug. Illustration 219 900627267 5. Remove the transmission breather that is located on the top of the transmission case. Install a new transmission breather. 6. Start the engine and run the engine at low idle. 2. Change the transmission oil filter element. Apply the service brake. Slowly operate the transmission controls in order to circulate the oil. Refer to Operation and Maintenance Manual, “Transmission Oil Filter - Replace”. 7.

Move the transmission control lever to NEUTRAL 3. Clean the transmission magnetic screen. and engage the parking brake. Inspect the Refer to Operation and Maintenance Manual, transmission for leaks. “Transmission Magnetic Screen - Clean”. E . & 8 Illustration 220 Illustration 218 g0062726¢ 900627264 4, Fill the transmission with transmission oil through the transmission filler tube. Refer to Operation and Maintenance Manual, “Lubricant Viscosities” and Operation and Maintenance Manual, “Refill Capacities”. 8. Maintain the transmission oil level between the “LOW? mark and the “HIGH” mark in the sight gauge when the transmission is warm and the engine is running.

Maintain the transmission oil level to the top of the sight gauge when the transmission is cooi and the engine is not running. Add transmission oil through the transmission filler tube, if necessary. Note: Check the transmission oil level by using the dipstick if the sight gauge is blocked. You may need to take more than one reading in order to achieve a consistent reading on the dipstick. The oil level needs to be maintained in the crosshatched area of the dipstick. The dipstick is attached to the oil fill cap. 9. Stop the engine.