155 Maintenance Section Transmission Oil Filter - Replace SEBU7645-06 101734082 Transmission Replace Oil Filter - SMCS Code: 3067-510 g00627269 lilustration 222 7. Maintain the transmission oil level between the “LOW’ mark and the “HIGH” mark on the sight gauge when the transmission is warm and the engine is running. Maintain the transmission Iitustration 221 g00627316 1. The transmission filter is located on the left side of the machine under the steps. Remove the transmission oil filter element with a strap type wrench. Clean the filter element mounting base. Remove any part of the filter element gasket that remains on the filter element mounting base.
Apply a light coat of oil to the gasket of the new filter element. oil level to the top of the sight gauge when the transmission is cool and the engine is not running. Add transmission oil, if necessary. Note: Check the transmission oil level by using the dipstick if the sight gauge is blocked. You may need to take more than one reading in order to achieve a consistent reading on the dipstick. The oil level needs to be maintained in the crosshatched area of the dipstick. The oil fill cap is also the dipstick. 8. Stop the engine. 101734092 a install the new filter element by hand.
When the gasket contacts the mounting base, tighten the filter element for an additional three quarters of a turn. Start the engine and apply the service brake. Slowly operate the transmission controls in order to circulate the transmission oil. Move the transmission contro! lever to NEUTRAL and engage the parking. Inspect the filter element for leaks. Transmission SMCS Code: Oil Level - Check 3030-535-FLV Check the transmission oil level while the machine is on a level surface. The sight gauge for the transmission oil level is located on the left side of the machine under the steps. Illustration 223 g00627269