156 Maintenance Section SEBU7645-06 Transmission Oil Sample - Obtain 1. Maintain the transmission oil level between the “LOW’ mark and the “HIGH” mark on the sight gauge when the transmission is warm and the engine is running. Maintain the transmission oil level to the top of the sight gauge when the transmission is cool and the engine is not running. Note: Check the transmission oil level by using the dipstick if the sight gauge is blocked. You may need to take more than one reading in order to achieve a consistent reading on the dipstick. The oil level needs to be maintained in the crosshatched area of the dipstick. The oil fill cap is also the dipstick.
Refer to Special Publication, SEBU6250, “Caterpillar Machine Fluids Recommendations’, “S-O-S Oil Analysis” for information that pertains to obtaining an oil sample. Refer to Special Publication, PEHP6001, “How To Take A Good Oil Sample” for more information about obtaining an oil sample. 101706737 Window Washer Fill Reservoir - SMCS Code: 7306-544 NOTICE When operating in freezing Caterpillar nonfreezing window temperatures, use washer solvent or equivalent. System damage can result from freezing. g00627264 lilustration 224 2. Remove the transmission filler plug and add transmission oil, if necessary. 3. Clean the filler plug and install the filler plug.
SoS g00627905 Illustration 226 102092030 Transmission Obtain Oil Sample - The window washer reservoir is located on the left side of the machine under the cab. Fill the reservoir with window washer solvent. SMCS Code: 3080-008; 7542-008 101740157 Window Wipers Inspect/Replace - SMCS Code: 7305-040; 7305-510 inspect the condition of the window wiper biades. Replace the window wiper blades if the window wiper blades are worn or damaged. If the window wiper blades streak the window, replace the window wiper blades. lHustration 225 g006 14038 Use the sampling valve in order to obtain a sample of the transmission oil. The engine must be running in order to take a sample of the transmission oil.