Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

19 Safety Section Fire Extinguisher Location SEBU7645-06 Ether Ether (if equipped) is commonly used in cold weather applications. Ether is flammable and poisonous. Follow the correct cold engine starting procedures. Refer to the section in the Operation and Maintenance Manual with the label “Engine Starting’. Do not spray ether manually into an engine if the machine is equipped with a thermal starting aid for cold weather starting. IHustration 11 g00687600 Check lines, tubes and hoses carefully. Wear Personal Protection Equipment (PPE) in order to check for leaks. Always use a board or cardboard when you check for a leak. Leaking fluid that is under pressure can penetrate body tissue.

Fluid penetration can cause serious injury and possible death. A pin hole leak can cause severe injury. If fluid is injected into your skin, you must get treatment immediately. Seek treatment from a doctor that is familiar with this type of injury. Replace the affected parts if any of the following conditions are present: e End fittings are damaged or leaking. e Quter coverings are chafed or cut. « Wires are exposed. « Outer coverings are swelling or ballooning. « Flexible parts of the hoses are kinked. Use ether in well ventilated areas. Do not smoke while you are replacing an ether cylinder or while you are using an ether spray.

Do not store ether cylinders in living areas or in the operator compartment of a machine. Do not store ether cylinders in direct sunlight or in temperatures above 49° C (120.2° F). Keep ether cylinders away from open flames or sparks. Dispose of used ether cylinders properly. Do not puncture an ether cylinder. Keep ether cylinders away from unauthorized personnel. Fire Extinguisher As an additional safety measure, keep a fire extinguisher on the machine. Be familiar with the operation of the fire extinguisher. Inspect the fire extinguisher and service the fire extinguisher regularly. Follow the recommendations on the instruction plate.

Consider installation of an aftermarket Fire Suppression System, if the application and working conditions warrant the installation. « Outer covers have exposed embedded armoring. e End fittings are displaced. Make sure that all clamps, guards, and heat shields are installed correctly. During machine operation, this 102813883 Fire Extinguisher Location SMCS Code: 7000 will help to prevent vibration, rubbing against other parts, excessive heat, and failure of lines, tubes and hoses. Make sure that a fire extinguisher is on the machine. Make sure that you are familiar with the Do not operate a machine when a fire hazard exists.

Repair any lines that are corroded, loose operation of the fire extinguisher. Inspect the fire extinguisher and service the fire extinguisher. Obey the recommendations on the instruction plate. or damaged. Leaks may provide fuel for fires. Consult your Caterpillar dealer for repair or for replacement parts. Use genuine Caterpillar parts or the equivalent, for capabilities of both the pressure limit and temperature limit.