20 SEBU7645-06 Safety Section Tire Information Illustration 13 g00337832 (A) At least 15 m (50 ft) (B) At least 500 m (1500 ft) Do not approach a warm tire. Maintain a minimum g01403012 Illustration 12 Mount the fire extinguisher on the left side of the machine on one of the legs of the ladder. This is the recommended location. Do not weld the ROPS in order to install the fire extinguisher. Also, do not drill holes in the ROPS in order to mount the fire extinguisher on the ROPS. distance, as shown. Stay outside the shaded area in Illustration 13. Do not use water or calcium as a ballast for the tires. Dry nitrogen gas is recommended for inflation of tires.
If the tires were originally inflated with air, nitrogen is still preferred for adjusting the pressure. Nitrogen mixes properly with air. Nitrogen inflated tires reduce the potential of Strap the mounting plate to a Jeg of the ladder in order to mount the fire extinguisher. If the weight of the fire extinguisher is more than 4.5 kg (10 Ib), mount the fire extinguisher.as low as possible on one leg. Do not mount the fire extinguisher on the upper one-third area of the leg. 101557411 Tire Information a tire explosion because nitrogen does not aid combustion. Nitrogen helps to prevent oxidation of the rubber, deterioration of rubber, and corrosion of rim components.
To avoid overinflation, proper nitrogen inflation equipment and training in the usage of the equipment are necessary. A tire blowout or a rim failure can result from improper equipment or from misused equipment. When you inflate a tire, stand behind the tread and SMCS Code: use a self-attaching chuck. 7000 Explosions of air inflated tires have resulted from heat-induced gas combustion inside the tires. Explosions can be caused by heat that is generated by welding, by heating rim components, by external fire, or by excessive use of brakes. A tire explosion is much more violent than a blowout.
The explosion can propel the tire, the rim components, and the axle components as far as 500 m (1500 ft) or more from the machine. Both the force of the explosion and the flying debris can cause property damage, personal injury, or death. Servicing tires and rims can be dangerous. Only trained personnel that use proper tools and proper procedures should perform this maintenance. If correct procedures are not used for servicing tires and rims, the assemblies could burst with explosive force. This explosive force can cause serious personai injury or death. Carefully obey the specific instructions from your tire dealer.