21 SEBU7645-06 Safety Section Electrical Storm Injury Prevention 101122596 Electrical Storm Prevention Inspect the condition of the seat belt and the condition of mounting hardware. Replace any damaged parts or worn parts. Regardless of appearance, replace the seat belt after three years of use. Do not use an extension for a seat belt on a retractable seat belt. Injury SMCS Code: 7000 Adjust the seat so that full pedal travel can be When lightning is striking in the vicinity of the machine, the operator should never attempi the following procedures: achieved. Make sure that the operator's back is against the back of the seat.
Make sure that the machine is equipped with a lighting system that is adequate for the job conditions. e Mount the machine. Ensure that all lights are in proper working condition. e Dismount the machine. Make sure that there are no personnel in the area If you are in the operator's station during an electrical storm, stay in the operator's station. If you are on the ground during an electrical storm, stay away from the vicinity of the machine. before you start the engine. Make sure that there are no personnel in the area before you move the machine. Make sure that there are no personnel on the machine, underneath the machine, or around the machine.
102813885 Before Starting Engine 103162317 Visibility Information SMCS Code: 1000; 7000 SMCS Code: 7000 Before you start the machine, perform a walk-around inspection in order to ensure that there are no hazards around the machine. While the machine is in operation, constantly survey the area around the machine in order to identify potential hazards as hazards become visible around the machine. Your machine may be equipped with visual aids. Some examples of visual aids are Closed Circuit Television (CCTV) and mirrors. Before operating the machine, ensure that the visual aids are in proper working condition and that the visual aids are clean.
Adjust the visual aids using the procedures that are located in this Operation and Maintenance Manual. if equipped, the Work Area Vision System shall be adjusted according to Operation and Maintenance Manual, SEBU8157, “Work Area Vision System’. lustration 14 g01403011 It may not be possible to provide direct visibility on large machines to ail areas around the machine. Make sure that the steering frame lock link is stored in the unlocked position. The steering frame lock link must be unlocked in order to steer the machine. Start the engine only from the operator's compartment. Never short across the starter terminals or across the batteries.
Shorting could bypass the engine neutral start system. Shorting could also damage the electrical system. Appropriate job site organization is required in order to minimize hazards that are caused by restricted visibility. Job site organization is a collection of rules and procedures that coordinates machines and people that work together in the same area. Examples of job site organization include the following: ¢ Safety instructions * Controlled patterns of machine movement and vehicle movement