Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

22 SEBU7645-06 Safety Section Engine Starting ° Workers that direct traffic to move when it is safe e Restricted areas shut position. ¢ Operator training « Warning symbols or warning signs on machines or on vehicles « Asystem Make sure that all windows are clean. Secure the doors in the open position or in the shut position. Secure the windows in the open position or in the For the best vision of the area that is close to the machine, adjust the rear view mirrors (if equipped). Make sure that the machine horn, the backup alarm (if equipped) and all other warning devices are working properly.

of communication e Communication between workers and operators prior to approaching the machine Fasten ithe seat belt securely. Modifications of the machine configuration by the i03738622 user that result in a restriction of visibility shall be evaluated. Operation 100861042 Engine Starting SMCS Code: 1000; 7000 If a warning tag is attached to the start switch or to the controls, do not start the engine. Also, do not move any controls. SMCS Gode: 7000 The machine will function satisfactorily in the anticipated ambient temperature limits that are encountered during operation. For operation in extreme temperatures, refer to Special Publication, SEBU5898, “Cold Weather Recommendations’.

Only operate the machine while you are in a seat. The seat belt must be fastened while you operate the Move all hydraulic controls to the HOLD position before you start the engine. machine. Only operate the controls while the engine is running. Move the direction control lever and the directional control switch (if equipped) to the NEUTRAL position. On a machine that is equipped with the remote While you operate the machine slowly in an open area, check for proper operation of all controls and all protective devices. directional control switch, the neutral light on the instrument panel should be lighted. Before you move the machine, you must make sure that no one will be endangered.

Engage the parking brake. Diesel engine exhaust contains products of combustion which can be harmful to your health. Do not allow riders on the machine unless the machine has the following equipment: Always start the engine in a well ventilated area. Always operate the engine in a well ventilated area. ¢ additional seat if you are in an enciosed area, vent the exhaust to ¢ additional seat belt the outside. ¢ Rollover Protective Structure (ROPS) 101665258 Before Operation SMCS Code: 7000 Clear all personnel from the machine and from the area. Clear all obstacles from the path of the machine. Beware of hazards such as wires, ditches, etc. Never use the work tool for a work platform.

Note any needed Ieee repairs IS OS during machine operation. Report any needed repairs. Carry work tools approximately 40 cm (15 inches) above ground level. Do not go close to the edge of a cliff, an excavation, or an overhang. If the machine begins to sideslip downward on a grade, immediately remove the load and turn the machine downhill.